The How & Why intake mounted PMD coolers for GM 6.5 Diesel and 6.5 Turbo Diesel Engines, do NOT work correctly.
The above image illustrates how heat builds up under the typical intake mount version of PMD coolers, one of our many initial designs was to mount with an "air-gap" between the cooler and the HOT engine, but then realizing that intake mounted cooler units still draw too much heat from the HOT engine, our founder Jim came up with the design of The PMD Remote Harness allowing our unit to be mount OFF & AWAY from the HOT engine!
Main web site page is at www.a1customs.com
© All images and text are property of this website, photographer and/or author and protected by Copyright. Disclaimer: By reading the website, readers understand and agree to all terms and conditions set forth on the site and herein and realize that although effort has been made to try to present accurate information this website, it could contain some errors, mistakes, opinion, and typos so use any information and with that in mind, if in doubt, reader should research anything they do not understand or question as reader is responsible for their own actions. There is no guarantee or warranty on information on this website or any other it links to and visitors agree to hold authors, page owners and internet service provider harmless and free from any liability arising from use of information provided on this website or any product purchased there from or via email. Website disclaimer, terms & conditions. The Magnus-Moss Warranty Act prohibits a dealer or manufacturer from voiding your warranty unless a product is directly responsible for a failure.